VQ30DET Forums
http://vqturbo.com/

VQ30det Reverse intake manifold
http://vqturbo.com/viewtopic.php?f=11&t=28
Page 1 of 1

Author:  GUN180 [ Mon Jun 01, 2015 2:45 pm ]
Post subject:  VQ30det Reverse intake manifold

Just for those that aren't aware, it is possible to "reverse" VQ engine intake manifolds...

Image

It does however make the throttle body impossibly high, even on my car it's a full 30mm to high to fit under my scoop...

Image

It could be quite useful for conversions with a lot of clearance though... A lot cheaper than modifying the manifold or buying a custom plenum for different intake options 8-)

Author:  NISfab [ Tue Jun 02, 2015 3:46 am ]
Post subject:  Re: VQ30det Reverse intake manifold

You can also mill the underside of the upper half of the plenum to get it lower but it will make the runner length shorter and you will lose some bottom to mid range torque

Author:  unkn0wn [ Wed Jun 10, 2015 5:26 pm ]
Post subject:  Re: VQ30det Reverse intake manifold

Unfortunately we have very little space up front anyway, so anything higher than stock is usually a massive disadvantage.

The one nisfab posted with the front TB looks really nice, but i doubt it does anything for out space issue.

Image

the one the 260z guy made looks good for clearance.

Image

Perhaps a hybrid of the two?

Page 1 of 1 All times are UTC + 8 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/